Vendor: NXP
Features: Ethernet, SDRAM, MicroSD, MicroUSB, Microphone, AudioCodec, SPDIF, CAN, Camera, OpenSDA, JLink
Source on GitHub: MIMXRT1060_EVK
More info: Website

The port for this board is experimental. It is made based on the documentation, but was not yet tested.

Installation instructions

Firmware can be loaded to the MIMXRT development boards in various ways. The most convenient one is using the built-in support MCU. When a PC is connected to the debug USB port, a drive icon will appear. Firmware can be uploaded to the board by copying it to this drive. The copy and flashing will take a few moments. At the end of the upload, the drive icon will disappear and reappear again. Then the reset button has to be pushed, which starts the MicroPython firmware.

Depending on the power jumper settings, both the debug USB and OTG USB port have to be powered during firmware upload.

You may as well load the firmware using the JLink port or openSDA interface with the appropriate tools. For more options, consult the user guide of the board.


Nightly builds

v1.17-207-g97a7cc243 (2021-11-29) .hex [.bin]
v1.17-205-gde8dc4bad (2021-11-26) .hex [.bin]
v1.17-202-ge99f7b6d2 (2021-11-25) .hex [.bin]
v1.17-196-g81f706aee (2021-11-25) .hex [.bin]