WeAct F411 'blackpill'. Default variant is v3.1 with no SPI Flash.

Installation instructions

Pyboard v1.x via DFU

One you have downloaded the appropriate DFU file it can be flashed directly to your pyboard using a DFU programmer. You can enter the DFU bootloader on the pyboard by executing machine.bootloader() at the MicroPython REPL.

Alternatively, connect 3V3 with BOOT0 and reset the board. For information about DFU programming on Windows see this PDF. For Linux and Mac see here.

Firmware

Preview builds

(These are automatic builds of the development branch for the next release)

Firmware (v3.1 board with 8MHz crystal)

No releases are available for this board.

Preview builds

(These are automatic builds of the development branch for the next release)

Firmware (v1.3 board with no SPI Flash)

No releases are available for this board.

Preview builds

(These are automatic builds of the development branch for the next release)

Firmware (v2.0 board with 4MB SPI Flash)

No releases are available for this board.

Preview builds

(These are automatic builds of the development branch for the next release)

Firmware (v1.3 board with 4MB SPI Flash)

No releases are available for this board.

Preview builds

(These are automatic builds of the development branch for the next release)

Firmware (v3.1 board with 8MB SPI Flash)

No releases are available for this board.

Preview builds

(These are automatic builds of the development branch for the next release)