Nucleo F746ZG

Vendor: ST Microelectronics
Source on GitHub: NUCLEO_F746ZG

Installation instructions

STM32 via ST-Link

Nucleo and Discovery boards typically include a built-in ST-Link programmer.

A .bin or .hex file can be flashed using st-flash.

# Optional erase to clear existing filesystem.
st-flash erase

# Flash .bin
st-flash write firmware.bin 0x08000000
# or, flash .hex
st-flash --format ihex write firmware.hex

A .hex file can be flashed using STM32 Cube Programmer. -c port=SWD -d firmware.hex -hardRst

STM32 via DFU

Boards with USB support can also be programmed via the ST DFU bootloader, using e.g. dfu-util or

To enter the bootloader the BOOT0 pin can be connected to VCC during reset, or you can use machine.bootloader() from the MicroPython REPL.

dfu-util --alt 0 -D firmware.dfu



v1.17 (2021-09-02) .dfu [Release notes] (latest)
v1.16 (2021-06-18) .dfu [Release notes]
v1.15 (2021-04-18) .dfu [Release notes]
v1.14 (2021-02-02) .dfu [Release notes]
v1.13 (2020-09-02) .dfu [Release notes]

Nightly builds

v1.17-220-gb491967bb (2021-12-06) .dfu [.hex]
v1.17-219-ga7fa18c20 (2021-12-03) .dfu [.hex]
v1.17-217-gde7e3cd79 (2021-12-01) .dfu [.hex]
v1.17-212-g23a150789 (2021-11-30) .dfu [.hex]