Vendor: Espressif
Features: BLE, WiFi
Source on GitHub: esp32/GENERIC_S3
More info: Website

Installation instructions

Program your board using the program, found here.

If you are putting MicroPython on your board for the first time then you should first erase the entire flash using: --chip esp32s3 --port /dev/ttyACM0 erase_flash

From then on program the firmware starting at address 0: --chip esp32s3 --port /dev/ttyACM0 write_flash -z 0 board-20210902-v1.17.bin



v1.19.1 (2022-06-18) .uf2 [.bin] [.elf] [.map] [Release notes] (latest)
v1.18 (2022-01-17) .bin [.elf] [.map] [Release notes]

Nightly builds

v1.19.1-994-ga4672149b (2023-03-29) .uf2 [.bin] [.elf] [.map]
v1.19.1-993-g283c1ba07 (2023-03-29) .uf2 [.bin] [.elf] [.map]
v1.19.1-992-g38e7b842c (2023-03-23) .uf2 [.bin] [.elf] [.map]
v1.19.1-991-g6c7624896 (2023-03-23) .uf2 [.bin] [.elf] [.map]