This is the documentation for the latest development branch of MicroPython and may refer to features that are not available in released versions.

If you are looking for the documentation for a specific release, use the drop-down menu on the left and select the desired version.

2. Using peripherals

For quick help information, please enter:

help()

You can access RA MCU’s peripherals using MicroPython modules. To list supported modules, please enter:

help('modules')

Especially machine module and class machine.Pin are very important for using peripherals.

Using “from machine import Pin”, Pin name is available corresponding to the RA MCU’s pin name which are Pin.cpu.P000 and ‘P000’. In addition, you can use ‘LED1’, ‘LED2’, ‘SW1’, and ‘SW2’ name if the board has these LEDs and switches.

2.1. LED blinking

As simple example, you can enter following program to blink LED1. Please enter key 4 times after the input of last time.sleep(1).

import time
from machine import Pin
led1 = Pin('LED1')
print(led1)
while True:
    led1.on()
    time.sleep(1)
    led1.off()
    time.sleep(1)

You can see the LED1 blinking per 1 second.

If you want to stop the program, please enter CTRL-C.

Traceback (most recent call last):
  File "<stdin>", line 5, in <module>
KeyboardInterrupt:

This message is displayed, and the program stops. The message means the program was interrupted at line 5 “while” statement.

Using print(led1), you can confirm that LED1 is assigned to Pin.cpu.P106 on the board.:

Pin(Pin.cpu.P106, mode=Pin.OUT, pull=Pin.PULL_NONE, drive=Pin.LOW_POWER)

So you can get the same result if Pin(Pin.cpu.P106) is specified instead of Pin(‘LED1’).

import time
from machine import Pin
led1 = Pin(Pin.cpu.P106)
print(led1)
while True:
    led1.on()
    time.sleep(1)
    led1.off()
    time.sleep(1)